Cardin Razza Official LCD Display Replacement

Key Features:

• Vivid Color LCD, identical to the ARK 2’s original display, delivering real-time speed, battery life, range, PAS settings, and diagnostics Cardin Razza Bikes

• Exact OEM match: Same wiring harness, pin configuration, firmware protocol, and interface for guaranteed compatibility

• Plug‑and‑play swap: Install in ~30 minutes following standard e-bike display replacement steps Amazon+7Leoguar Ebikes+7LETRIGO+7

• Integrated control panel: Supports PAS levels, head/tail lights, cruise control, error codes, and walk mode

• Robust build: Water-resistant housing, anti-glare panel, operating range from −20 °C to +60 °C

• Factory-authorized part: Maintains warranty and preserves all proprietary features on Cardin Razza systems

Compatibility & Installation Tips:

1. Confirm your e‑bike model (e.g. Sol 3, MOSES R1, ARK S, ARK 2) uses Cardin Razza’s factory color LCD design

2. Verify cable connector, button layout, and display harness match your current setup

3. Power off the bike and disconnect the battery before you begin

4. Remove the old display by unclipping the wiring and undoing handlebar bolts

5. Plug the new display in, secure it on the handlebar, reconnect power, and power on to test functionality

6. If blank or error codes appear, double-check connections and consult support

Why It Matters:

• Restores full dashboard functionality — avoids using partial or generic units that may omit features

• Protects investment — OEM replacement preserves warranty and overall system reliability

• DIY friendly — clear install steps take about half an hour; ideal for savvy riders or service shops